E31 Multi-Pattern Front Hubs and Bearings - Multihub

E31 Multi-Pattern Front Hubs and Bearings - MultihubWe designed these hubs allow you to run almost any of the popular 5 bolt wheels you can get your hands on. This makes it much easier to source drift spares, fit awesome looking wheels you never could before, and super easy to swap to different wheels but just spinning your brake rotor. The patterns on this hub include: 5x112 5x114. 3 5x120 5x127 (aka. 5x5) These are drilled and tapped to M14x1. 5. Requires use of M14x1. 5 wheel bolts or thread in

We designed these hubs allow you to run almost any of the popular 5 bolt wheels you can get your hands on. This makes it much easier to source drift spares, fit awesome looking wheels you never could before, and super easy to swap to different wheels but just spinning your brake rotor.

The patterns on this hub include:
5x112
5x114.3
5x120
5x127 (aka. 5x5)

These are drilled and tapped to M14x1.5. Requires use of M14x1.5 wheel bolts or thread-in wheel studs, sold separately.

Sold as a set (2 lug conversion hubs)

To install you just remove your rotors from your E31 and drill out all 5 holes to 20mm using a step drill (unibit). Then when everything is back on your car, you simply rotate your rotors to the pattern you want to use and bolt your wheels on. Takes just a couple seconds to swap patterns!

You will no longer use the little screw that further bolts the rotor on, this is not needed.